.png){kind=logo}
If your shower went cold or your water heater is leaking, you dont’ need a big speech. You need hot water back. ZH Plumbing and Water Heaters provides Water Heater Repair Los Angeles homeowners call when it’s urgent, confusing, or messy.
We’ve been doing this since 2003. We’re based in Valley Village and we work all over Los Angeles - Studio City, Sherman Oaks, Van Nuys, North Hollywood, Hollywood, Burbank, Glendale, Pasadena, Beverly Hills, Santa Monica, Northridge, Panorama City, and more.
Call now: (855) 500-7473
Address: 12730 Califa St, Valley Village, CA 91607
Licensed & insured • Financing available • 100% Satisfaction Guarantee
Water Heater Repair Los Angeles
$1900 Rebate Eligibility Available Call Now
Call (855) 500-7473 or receive your online quote to learn more about the number one water heater repair and replacement services in Los Angeles!
Looking for fast Water heater Repair in Los Angeles? Call (855) 500-7473 now and schedule quick water heater repair with a licensed professional.
Water Heater Repair Around Greater Los Angeles
When the nights get colder in the Valley, we get a run of calls from Sherman Oaks and Studio City for the same thing: “no hot water” or “it goes warm then cold.” A lot of the time it’s a tired thermostat, a dirty sensor, or sediment buildup in the tank. Sometimes it’s the unit telling you it’s near the end.
If you’re not sure what’s going on, that’s normal. We’ll check it, explain it simple, and give you options.
Signs You Need Same Day Emergency Water Heater Repair
-
No hot water at all
-
Water heater leaking from the top, bottom, or valve
-
Pilot light keeps going out (gas)
-
Breaker keeps tripping (electric)
-
Popping / rumbling noise (often sediment)
-
Water too hot or not hot enough
-
Rusty or smelly hot water
-
Tankless error codes, temp swings, or shutdowns
What makes tankless installs more expensive in Los Angeles
Gas line sizing and routing
A lot of LA homes—especially older ones—weren’t set up for the BTU demand of a modern gas tankless. If the line needs upsizing or rerouting, cost rises fast.
New venting (and sometimes condensate)
Gas tankless units often require a specific venting setup. If your current water heater vent can’t be reused, you’re paying for new vent materials and routing.
Electrical upgrades
Even gas units need power, and electric tankless may require significant electrical capacity. If your panel is already packed (common in older LA houses and multi-units), you may need additional electrical work.
Access and building type
Garage installs are often simpler. Tight closets, attic runs, and multi-family buildings add labor and coordination.
1) The unit (the biggest variable)
Your tankless heater price depends on brand, flow rate (GPM), efficiency, and whether it’s condensing. A typical whole-home unit is often in the hundreds to low-thousands before labor.
2) Labor
Labor is a large slice of the job because tankless installs have more steps than a basic tank replacement: mounting, water connections, gas sizing checks, venting, condensate (for many high-efficiency units), testing, and setup.
3) Materials
Even “simple” installs usually include parts like isolation valves, flush kit components, fittings, gas shutoff/connector changes, vent pieces, and mounting hardware.
4) Permits and inspections (common in LA)
In Los Angeles, many installs involve work that can trigger permitting—especially anything involving gas piping or venting changes. This matters because it affects timeline and total cost, but it also protects you if you ever sell the property or have an insurance claim.
What you’re actually paying for (cost breakdown)
In Los Angeles, most homeowners pay about $1,600 to $3,800 to install a tankless water heater, with an average around $2,700 for a straightforward install. Your final price depends mainly on the unit you choose, whether it’s gas or electric, and whether your home needs upgrades like new venting, a larger gas line, or electrical work.
Tankless Water Heater Installation Cost in Los Angeles
Why homeowners choose us for Water Heater Repair Los Angeles
Homeowners choose ZH Plumbing and Water Heaters for water heater repair in Los Angeles because we make the whole situation simple and stress free We’ve been doing this since 2003 and we’re based in Valley Village so we’re regularly out in Studio City Sherman Oaks Van Nuys North Hollywood Burbank Glendale Pasadena Hollywood Beverly Hills Santa Monica Northridge and Panorama City We work on water heaters every day gas electric and tankless which means faster diagnosis and the right fix the first time You get clear options and upfront pricing before any work starts plus honest advice on repair vs replacement if the tank is failing or leaking from the bottom We also check the safety basics like shutoffs venting and pressure relief and we keep the job clean so you can get back to normal life with reliable hot water again
Signs You Need Water Heater Repair in Los Angeles
In Los Angeles, water heaters get worked hard—especially in busy households and multi-unit buildings. And because a lot of LA water is on the harder side, mineral scale can build up faster and show up as noise, reduced hot water, and inconsistent temperatures
Call for water heater repair if you notice any of these
-
No hot water or only lukewarm water (unit isn’t heating consistently)
-
Hot water runs out faster than normal (common when sediment/scale reduces capacity)
-
Water temperature swings (hot → cold → hot)
-
Rumbling / popping / banging sounds (often linked to sediment/scale buildup)
-
Rusty or discolored hot water (can point to internal corrosion or an anode issue)
-
Water pooling around the base or drips at fittings/valves (leaks can escalate into damage fast)
-
Dripping from the relief line (TPR discharge) (can indicate overheating/pressure issues—this safety system matters)
-
Pilot light keeps going out / ignition problems on gas units
-
Tankless error codes or mid-shower cold water (flow, sensor, venting, or maintenance-related issues)
Emergency warning (call immediately)
If you smell gas, see soot, feel dizzy/headachy near a gas appliance, or a CO alarm goes off—leave the home and get help right away. Fuel-burning appliances can create carbon monoxide risk if venting fails, and CPSC emphasizes CO safety and alarms.
If you want, paste your current “Water Heater Repair” section and I’ll rewrite it in the same voice as your site (short, direct, high-converting) while keeping it LA-specific.
Our LA Water Heater Repair Process
Quick Dispatch and Same Day Diagnosis in Los Angeles
When you call for water heater repair in Los Angeles, we start by confirming your area and routing the closest technician for fast arrival. We regularly dispatch across the San Fernando Valley including Valley Village, Studio City, Sherman Oaks, North Hollywood, Van Nuys, and Encino, and we also cover Hollywood, Koreatown, Mid City, DTLA, Silver Lake, and Culver City. If you’re near familiar spots like Universal Studios Hollywood, Griffith Park, or LAX, we’ll use those landmarks to pinpoint your location and reduce delays. The goal is simple get eyes on the problem quickly so you’re not stuck without hot water.
Full Water Heater Safety Check and Clear Cause Identification
On site, we do a structured inspection to find the real cause not just the symptom. For tank water heaters, we check the gas control valve, burner assembly, thermocouple, thermostat, heating elements, relief valve, and signs of corrosion or sediment buildup. For tankless water heater repair in Los Angeles, we look at error codes, ignition, airflow and venting, water flow rate, sensors, and scale from hard water, which is common across many LA neighborhoods. We’ll explain what failed, what’s safe to run, and what needs attention right now to avoid bigger damage like leaks, water staining, or shutdowns.
Upfront Repair Options and No Pressure Recommendations
After diagnosis, you’ll get straightforward repair options with upfront pricing before any work starts. If it’s a fix that makes sense we’ll recommend the most cost effective route whether that’s replacing a thermocouple, resetting and testing a tankless ignition system, repairing a pilot light issue, swapping a heating element, or addressing a pressure relief valve leak. If the unit is older or the tank is failing, we’ll tell you honestly when replacement is the smarter long term option. Homeowners across Beverly Grove, West Hollywood, Glendale edges, and the Valley appreciate that we keep it practical and focused on getting reliable hot water back.
Repair Completed Tested and Hot Water Restored
Once you approve the repair, we handle the work cleanly and finish with proper testing so you can trust the system. We verify stable temperatures at fixtures, check for leaks, confirm safe venting, and make sure the heater cycles correctly under normal household demand. For tankless systems, we’ll also advise on descaling schedules to prevent repeat issues especially in parts of LA where mineral buildup is common. Before we leave, you’ll know exactly what was repaired, what to watch for, and how to keep your water heater running smoothly in Los Angeles year round.
Where we do Water Heater Repair in LA
We’re based in Valley Village and we do Water Heater Repair Los Angeles across the Valley and nearby areas. A lot of our calls come from:
-
Valley Village
-
Studio City
-
Sherman Oaks
-
Van Nuys
-
North Hollywood
-
Hollywood
-
Burbank
-
Glendale
-
Pasadena
-
Beverly Hills
-
Santa Monica
-
Northridge
-
Panorama City
-
Santa Clarita
To make sure your boiler works smoothly in winter and every season, you need to carefully choose a reliable boiler company in Los Angeles. A boiler service should be followed by experience, license and service quality. This is what ZH Plumbing delivers.
We repair, install and offer maintenance as per local codes and proven methods. Here are some reasons as to why we're the top choice of boiler repair service in Los Angeles.
Why Choose ZH Plumbing To Repair Your Water Heater In LA
20+ Years of Water Heater and Plumbing Experience
ZH Plumbing has been providing services in Los Angeles for over 20 years to both residential and commercial Water Heater systems. Our vast experience guides us to correctly diagnose, repair and properly plan Water Heater installations.
5,000+ Happy Clients Across Los Angeles
Thousands of homeowners and businesses trust ZH Plumbing for reliable service. Our consistent workmanship, clear communication and dependable results are the reasons behind long term client relationships.
Licensed and Code Compliant Water Heater Services
All of our Water Heater services follow licensed and insured standards required in Los Angeles. We follow local safety codes in each repair and installation process. This reduces risk and ensures proper safety.
Complete Water Heater Solutions Under One Roof
We offer every service related to Water Heater by one dedicated team. Either you need boiler repair, maintenance, replacement or installation, ZH Plumbing will manage all of your Water Heater repair needs.
FAQs
If you have a gas water heater, the most common cause is a pilot light or ignition issue (or the gas supply is off). If you have an electric unit, check for a tripped breaker or a tripped high-limit (ECO) safety switch—if it keeps tripping, a thermostat or heating element may be failing and needs service.
This is usually a capacity problem, not a “no hot water” problem: common causes include low thermostat setting, sediment buildup reducing usable tank volume, a broken/short dip tube mixing cold and hot water, or (on electric units) a failed lower heating element.
A T&P valve usually drips because the system is relieving excess temperature/pressure—often due to high water pressure or thermal expansion (common when a home has a check valve/PRV and “closed” plumbing). Sometimes the valve itself is worn or has debris, but don’t ignore it—T&P issues are a real safety risk.
Most “popping/rumbling” in tank heaters comes from sediment/mineral buildup on the bottom of the tank—water trapped under the scale boils and “pops.” Flushing can help, but if the noise is new, loud, or paired with poor performance, get it checked before it damages components.
First figure out where the leak starts: leaks from fittings/valves at the top are often repairable, while leaking from the tank itself (especially the bottom seam) often means internal corrosion and replacement is usually the safe call. Any active leak can worsen quickly, so it’s worth shutting off water/power and getting it inspected.
A rotten-egg smell is commonly hydrogen sulfide linked to bacteria and reactions inside the tank (often involving the anode rod). Fixes usually involve flushing/disinfecting and sometimes anode changes—but if the smell seems like natural gas near the heater, treat it as an emergency and call your gas utility from outside.
Rusty/discolored hot water can point to anode rod deterioration, iron bacteria, or internal tank corrosion. If it’s mainly on the hot side, your heater is a prime suspect; a plumber may recommend a flush and anode inspection, and if corrosion is advanced, replacement may be more cost-effective.
The red reset is the high-limit (ECO) safety—if it trips, the unit may be overheating due to a faulty thermostat, wiring issue, or a heating element problem/short. You can reset it once, but if it trips again, stop cycling it and have it diagnosed.
Schedule Professional Water Heater Repair in Los Angeles
If you need Water Heater Repair Los Angeles, call ZH Plumbing and Water Heaters. We’ll make it simple, fix what’s needed, and help you get hot water back.
